Quickly repair ends on wheel studs, bolts, and threaded rod by removing burred and damaged ends

Easily repairs threads in place, eliminating the time and cost of replacing hard-to-find or expensive hardware

The 3 long lasting tungsten carbide cutting blades with a hardness rating between 88-90 HRC are durable enough to use on most metals leaving a clean thread end

Operation: Using the lowest drill gear; rotate bit between 0 - 400 RPM and apply consistent forward pressure evenly, until the damaged threads have been removed

Bit capacity of 1/8 - 3/4" (3 - 19mm) and can be used with most materials including stainless steel, aluminum, plastic, or wood

NOTE: Use above recommended RPM or with hammer/impact drills will destroy cutting edge of tool